Blue Ridge Sealants & Waterproofing, LLC

Winchester, VA 22603

Company Info

SCOPE OF WORK FOR THRU-WALL FLASHING

- Mobilize material, labor and equipment to job site.
- Set Up swing stage and move as needed to perform the flashing work at the 6 balcony areas.
- Remove one row of decorative block, clean and set aside for reuse.
- Using Wire wheel clean off all deterioration and rust on metal lintels.
- Coat lentils with rust inhibitor paint.
- Install thru wall flashing using Perma Barrier, mastic, end dams and termination bar; 248 linear

feet total for all 6 balconies.

NOTE: The new flashing will overlap with the existing vinyl membrane.
- Replace decorative block matching mortar as close as possible to existing
- Demobilize and remove all job related debris from site.

SCOPE OF WORK FOR GLASS TO METAL SEALANTS, WINDOW PERIMETER AND CONTROL JOINT SEALANTS

- At all windows except for those previously repaired, cut back gaskets if needed and/or remove deteriorated sealants if present.
- Wipe area clean with alcohol to receive new silicone glazing.
- Install Dow Corning 795 Black silicone creating a 45 degree cant joint at glass to metal locations.
- At window perimeters on the first and second floor and at both entrances, remove old and

deteriorated sealants and discard off site.
- Prep areas to receive new urethane sealant by cleaning free of dust , dirt and debris.
- Install the appropriate primer, backer-rod and NP1 urethane sealant. Tool all joints per industry

standards.
- At all vertical control joints (except what has been replaced above the third floor), remove old

and deteriorated sealants and discard off site.
- Prep areas to receive new urethane sealant by cleaning free of dust, dirt and debris.
- Install the appropriate primer, backer-rod and NP1 urethane sealant. Tool all joints per industry

standards.
- Demobilize and remove all job related debris from site.