Image Gallery

#251: Z Wire Tie (No Drip)

Use to bond masonry veneer to a masonry back-up wall.

#251: Z Wire Tie (No Drip)

#253: Rectangular Wire Tie (No Drip)

Use to bond masonry veneer to a masonry back-up wall.

#253: Rectangular Wire Tie (No Drip)

#78 Flat Split-Bend Stone Anchor

1/8" thick Stainless Steel x 2" wide. Pintles are 1-1/8" apart for placement into the ThermalClip®. Vertical Adjustability is 1".

#78 Flat Split-Bend Stone Anchor

#78-P: Pintle Pin-Type Stone Anchor

#78-S: Pintle Split-Bend Stone Anchor

Barrel Lengths

sheathing thickness: 5/8" 1" 1-1/2" 2" 2-1/2" 3" 3-1/2" 4" 4-1/2" Once the barrel-screw is in place, the wire tie is installed into the barrel. The loop in the tie allows approximately 1-1/4" of vertical adjustment above and 1-1/4" below the barrel for placement in the brick veneer mortar joint.

Barrel Lengths

Channel Slot Partition Anchor

Channel Slot System

Use versatile channel-slots and anchors to attach masonry or stone veneer to new or existing masonry, concrete, or steel structures or walls. Available in stainless, hot dipped galvanized, mill galvanized, or plain. Channel Slot Systems are to be used with Channel Anchors. Standard and custom Channel Anchors are available in a variety of materials and finishes.

Channel Slot System

Chuck Adapter

The Chuck Adapter is a special tool for the Pos-I-Tie® designed for proper installation. The Chuck Adapter will fit any standard power drill.

Chuck Adapter

Concrete/Cmu Screw

USED FOR: Concrete CMU ICF Wood Brick

Concrete/Cmu Screw

Concrete/Cmu Screw

Double Pintle Wire Tie

Standard Tie lengths are 3", 3-1/2", 4", and 5". They are available in 3/16 diameter Mill Galvanized Steel, Stainless Steel, and Hotdip Galvanized After Fabrication. Double Pintle Wire Ties can be modified with a 20 gage Seismic Hook tab for holding masonry reinforcement or pencil rod. These are factory welded to the Pos-I-Tie® Wire Ties and meet Seismic Zone requirements.

Double Pintle Wire Tie

Flat Split-Bend Stone Anchor

1/8" or 3/16" thick Stainless Steel x 1-1/4" or 1-1/2" wide, 3/4" split bends Lengths Made to Order

Flat Split-Bend Stone Anchor

Elmhurst Memorial Hospital

United Center

Buckingham Fountain

John Hancock Building

Seismic Triangle Wire Tie

Self Drilling Screw

USED FOR: Steel Stud Extra long screws available for special applications

Self Drilling Screw

Self Drilling Screw

Services

Services

Single Pintle Wire Tie

Sleeve Tool

Sleeve tool features an integrated drill bit while allowing attachment of the Pos-I-Tie® Chuck Adapter. When installing the Pos-I-Tie® into a concrete, CMU, wood, brick or ICF, it may be necessary to pre-drill a pilot hole. The Sleeve Tool will allow you to switch easily between drill bit and chuck adapter.

Sleeve Tool

Structural Steel Screw

USED FOR: Up to 1/2" Thick Structural Steel

Structural Steel Screw

Structural Steel Screw

Triangle Wire Tie

Wire and Plate Stone Anchor

3/16" diameter Stainless Steel Wire Plate-type is 1/8" thick Lengths Made to Order

Wire and Plate Stone Anchor

Wire Stone Anchor

3/16" diameter Stainless Steel Wire Lengths Made to Order

Wire Stone Anchor